Paper Title :An Experimental Study To Identify The Design Variants In Design And Developing A Single Column Classifier
Author :Bharath N, Siddhartha.Kodgi, Akash.Sonthalia, Swapnil.Urankar
Article Citation :Bharath N ,Siddhartha.Kodgi ,Akash.Sonthalia ,Swapnil.Urankar ,
(2014 ) " An Experimental Study To Identify The Design Variants In Design And Developing A Single Column Classifier " ,
International Journal of Mechanical and Production Engineering (IJMPE) ,
pp. 26-30,
Volume-2,Issue-9
Abstract : Classifiers are used in minerals processing for extracting the valuable minerals. Effectiveness of classifier depends
on how effectively the classification of particles is been done based on the cut size. The main factor is teeter bed formation
which has high impact on classification of particles depending on their size and density. Heavy particles move to underflow
and the lighter particles move towards the overflow. The separation of lighter and heavy particle takes place at teeter bed. In
this study, teeter bed is the primary focus area to understand the cut size particle behavior and enhance the effectiveness of
the teeter bed in classification process. Experimental work is carried out using single column cylindrical classifier built in
transparent material to study the particle behavior in teeter bed. Known quantity of sand slurry with different particle sizes is
prepared and the classification results are tabulated and analyzed. From the analysis it is clear that stability of teeter bed is a
key factor in achieving high efficiency in classification process. The various factors hampering the stability of teeter bed are
induced due to agitation leading to variation of slurry concentration per cycle during the process and slurry pumping rate and
pulsation in pumping.
Type : Research paper
Published : Volume-2,Issue-9
DOIONLINE NO - IJMPE-IRAJ-DOIONLINE-1230
View Here
Copyright: © Institute of Research and Journals
|
|
| |
|
PDF |
| |
Viewed - 52 |
| |
Published on 2014-09-03 |
|