Paper Title :Experimental Study of Wear Ratio on Superni-600 (Super Alloy) using Powder Mixed EDM
Author :Dharminder Singh, Arvind Kalia, Bhuvnesh Magon, Abhay Sondhi
Article Citation :Dharminder Singh ,Arvind Kalia ,Bhuvnesh Magon ,Abhay Sondhi ,
(2017 ) " Experimental Study of Wear Ratio on Superni-600 (Super Alloy) using Powder Mixed EDM " ,
International Journal of Mechanical and Production Engineering (IJMPE) ,
pp. 7-18,
Volume-5,Issue-12
Abstract : The work piece into consideration i.e. Superni 600 is very difficult to be machined with conventional machining
processes due to very high hardness of the material. Electrical Discharge Machining (EDM) has been regarded as the best
method for machining of complex materials with greater values of hardness such as superni 600 super–alloy. In this research
work, an attempt has been made to machine Superni 600 material with Abrasive Electrical Discharge Machining (AEDM)
process. Input parameters such as peak current, pulse on time, gap voltage and concentration of abrasives in dielectric fluid
were taken into account. MRR (Material Removal Rate), TWR (Tool Wear Ratio) and Wear Ratio were regarded as output
resulting parameter. Taguchi method was employed to plan and design (orthogonal array) experimentation. Results show
that machining of Superni 600 is possible with EDM technology and all the input parameters have appropriate effect on
MRR, TWR and Wear ratio of the work piece.
Index terms - EDM, AEDM, MRR (Material Removal Rate), TWR (Tool Wear Ratio), WR (Wear Ratio) and Taguchi
method.
Type : Research paper
Published : Volume-5,Issue-12
Copyright: © Institute of Research and Journals
| |
 |
| |
 |
PDF |
| |
Viewed - 85 |
| |
Published on 2018-01-31 |
|
