Paper Title :Experimental Optimization of Machinability Parameters in Drilling of He30 Aluminium Alloy Kingpin Bush
Author :Undure Vedant P., Patil Dhiraj D., Raut Nakeeb P., Sakpal Sagar A., Sakharkar Sagar N., V. Murli Mohan
Article Citation :Undure Vedant P. ,Patil Dhiraj D. ,Raut Nakeeb P. ,Sakpal Sagar A. ,Sakharkar Sagar N. ,V. Murli Mohan ,
(2017 ) " Experimental Optimization of Machinability Parameters in Drilling of He30 Aluminium Alloy Kingpin Bush " ,
International Journal of Mechanical and Production Engineering (IJMPE) ,
pp. 25-31,
Volume-5,Issue-7
Abstract : The surface finish of drilled components affecton fatigue life and endurance strength which influences dynamic
performance. This paper is focused on achieving higher surface finish and optimized machin ability parameters to
manufacture high quality of Kingpin Bush using RSM technique. HE30 (6082) aluminium alloy is drilled for Kingpin bush
application on CNC Lathe machine. The surface roughness is measured using Mitutoyo SJ210 surface roughness tester and
SEM photographs are taken by LEICAStereoscan 440. Three variable parameters i.e. spindle speed 600-800 rpm, feed 0.05-
0.08 mm/rev and point angle 900-1160are selected for machinability assessment. RSM-CCD experimental desirability
approach suggested 793 rpm spindle speed, 0.0517mm/rev feed and 1100 point angle for minimum surface roughness of
0.27μm theoretical and 0.293 found during experiment. SEM photographs of optimal desirable solution focused on texture of
machined surface.
Keywords - Kingpin bush, HE30 Al alloy, RSM, Surface roughness, SEM.
Type : Research paper
Published : Volume-5,Issue-7
DOIONLINE NO - IJMPE-IRAJ-DOIONLINE-8672
View Here
Copyright: © Institute of Research and Journals
| |
 |
| |
 |
PDF |
| |
Viewed - 74 |
| |
Published on 2017-09-11 |
|
