Paper Title :Mechanical Properties of Friction Stir Welded 3003 Aluminum Alloy in Different Welding Conditions
Author :Hakan Aydin, Mumin Tutar, Kurtulus Yigit, Ali Bayram
Article Citation :Hakan Aydin ,Mumin Tutar ,Kurtulus Yigit ,Ali Bayram ,
(2017 ) " Mechanical Properties of Friction Stir Welded 3003 Aluminum Alloy in Different Welding Conditions " ,
International Journal of Mechanical and Production Engineering (IJMPE) ,
pp. 92-96,
Volume-5,Issue-12
Abstract : The effect of welding parameters (rotation speed and welding speed) on the mechanical properties of 3003-H12
aluminum alloy joints produced by friction stir welding. The mechanical performances of the joints were evaluated using
tensile tests and the relationships between welding parameters and joint performances were investigated. The weld strength
increased with increasing the welding speed or decreasing the rotation speed. The location of tensile fractures of the joints is
base metal at welding parameter combinations of 1070 rpm and 40 mm/min or 2140 rpm and 224 mm/min. All other joints
were failed at heat affected zone. The yield and ultimate tensile strengths of the joints decreased almost linearly with
increasing rotation speed at a constant welding speed, while these strengths of the joints increased almost linearly with
increasing welding speed at a constant rotation speed. But, a significant correlation could not be established between welding
parameters and elongation of the joints. However, the elongation values of FSW joints is relatively lower at higher rotation
speed or lower welding speed.
Keywords - Friction Stir Welding, 3003 Aluminum Alloy, Welding Parameters, Mechanical Properties.
Type : Research paper
Published : Volume-5,Issue-12
Copyright: © Institute of Research and Journals
| |
 |
| |
 |
PDF |
| |
Viewed - 51 |
| |
Published on 2018-03-06 |
|
