Paper Title :Multi-Response Optimization Of CNC WEDM Process Parameters For Machining Inconel 718 Using Taguchi Grey Relational Analysis (TGRA)
Author :B. Satyanarayana, G. Srikar
Article Citation :B. Satyanarayana ,G. Srikar ,
(2014 ) " Multi-Response Optimization Of CNC WEDM Process Parameters For Machining Inconel 718 Using Taguchi Grey Relational Analysis (TGRA) " ,
International Journal of Mechanical and Production Engineering (IJMPE) ,
pp. 35-41,
Volume-2,Issue-10
Abstract : WEDM process is extensively used in the machining of conductive materials when the prime importance of the
operation is precision. This paper presents the investigation of material removal rate, kerf width, and wire wear ratio of
WEDM process on INCONEL 718. Using Taguchi’s parameter design, significant machining parameters affecting the
performance measures are identified as pulse off-time, pulse on-time, water flowrate, wire feed, and wire tension. The effect
of each parameter is studied individually using the plots of signal to noise ratio.
Type : Research paper
Published : Volume-2,Issue-10
DOIONLINE NO - IJMPE-IRAJ-DOIONLINE-1306
View Here
Copyright: © Institute of Research and Journals
| |
 |
| |
 |
PDF |
| |
Viewed - 66 |
| |
Published on 2014-10-01 |
|
