Paper Title :Parametric Optimization Of CNC Wire Cut EDM For OHNS Steel Using Moora Methodology
Author :Vedansh Chaturvedi, Anil Kumar Sharma
Article Citation :Vedansh Chaturvedi ,Anil Kumar Sharma ,
(2014 ) " Parametric Optimization Of CNC Wire Cut EDM For OHNS Steel Using Moora Methodology " ,
International Journal of Mechanical and Production Engineering (IJMPE) ,
pp. 55-60,
Volume-2,Issue-12
Abstract : The selection of optimum machining condition, during wire electric discharge machining process, is of great
concern in manufacturing industries these days the increasing quality demands, at higher productivity levels, require the wire
electrical discharge machining process to be executed more efficiently. Specifically, the MRR needs to be maximized while
controlling the surface quality. In this study oil harden non- shrinking (OHNS) steel is used as a work piece, brass wire of
diameter 0.25 mm used as a tool and distilled water is used as a dielectric fluid. For experimentation Taguchi’s
Lଶହorthogonal array has been used. The input parameters selected for optimization are wire tension, wire feed rate, flushing
pressure, servo feed rate. by using parametric optimization technique, MOORA method, best parametric combination is
found.
Keywords- MRR, SR, OHNS, MOORA Method.
Type : Research paper
Published : Volume-2,Issue-12
DOIONLINE NO - IJMPE-IRAJ-DOIONLINE-1567
View Here
Copyright: © Institute of Research and Journals
| |
 |
| |
 |
PDF |
| |
Viewed - 81 |
| |
Published on 2014-12-03 |
|
