Paper Title :Design and Fabrication of Semiautomatic Noodles-Making Machine
Author :Po Po Thin, Htay Htay Win, Aung Kyaw Soe
Article Citation :Po Po Thin ,Htay Htay Win ,Aung Kyaw Soe ,
(2024 ) " Design and Fabrication of Semiautomatic Noodles-Making Machine " ,
International Journal of Mechanical and Production Engineering (IJMPE) ,
pp. 35-42,
Volume-12,Issue-6
Abstract : This paper focuses on the design and fabrication of a semiautomatic portable noodles-making machine. A very
high stress is affected at the end near the frictionless support of the noodles cutting shaft. The grooves and cutters of shaft
wear, corrosion, and fatigue can fail the noodles cutting shaft. The design and static structural analysis of the noodles cutting
shaft are presented by changing three different materials (AISI 1020, ASTM A 36, and ASTM A 220). The length of the
cutting shaft was 220 mm, and the calculated diameter of the shaft was 14mm by using the ASME code equation. In the
theoretical and numerical analysis, the minimum von-Mises stress and effective strain are found on AISI 1020 carbon steel
by using ANSYS 17.0 software. Thus, AISI 1020 carbon steel is more suitable than the other two materials for noodles
cutting shafts. The noodles roller has a 50mm diameter and 147mm length, and 27.34g is produced per revolution of the
roller. The maintenance-free plain bush bearings were used to support the noodles cutting shaft.
Keywords - Noodles cutting shaft, Noodles-making machine, Noodles roller, Plain bush bearing, Static structural analysis
Type : Research paper
Published : Volume-12,Issue-6
DOIONLINE NO - IJMPE-IRAJ-DOIONLINE-20920
View Here
Copyright: © Institute of Research and Journals
|
 |
| |
 |
PDF |
| |
Viewed - 19 |
| |
Published on 2024-09-20 |
|