Paper Title :Numerical Analysis of Rice Polishing Machine Shaft With Different Blade Widths and Thicknesses
Author :Thida Win, Htay Htay Win, Aung Ko Latt
Article Citation :Thida Win ,Htay Htay Win ,Aung Ko Latt ,
(2024 ) " Numerical Analysis of Rice Polishing Machine Shaft With Different Blade Widths and Thicknesses " ,
International Journal of Mechanical and Production Engineering (IJMPE) ,
pp. 39-45,
Volume-12,Issue-10
Abstract : This paper focuses on the numerical analysis of rice polishing machine shaft with different blade widths and
thicknesses. The diameter of rice polishing machine shaft is 22mm and the length of 400mm. The numerical analysis of rice
polishing machine shaft was performed by using ANSYS 17 software. In this paper, von-Mises stress and effective strain are
analyzed by changing the blade width of 6mm, 8mm, 10mm, 12mm and 14mm and the thickness of 2mm, 4mm, 6mm, 8mm
and 10mm, respectively. The comparison results of theoretical and numerical of equivalent(von-Mises) stress and effective
strain are presented. Although the equivalent (von-Mises) stress of all blade widths and thickness are less than allowable stress
of the material, the blade width of 10mm and thickness of 6mm is chosen due to the broken efficiency is less than other two
less blade widths and thicknesses and milling capacity is more than other two large blade widths and thickness.
Keywords - Blade, Width, Thickness, Effective stress, Strains
Type : Research paper
Published : Volume-12,Issue-10
Copyright: © Institute of Research and Journals
| |
 |
| |
 |
PDF |
| |
Viewed - 9 |
| |
Published on 2025-02-10 |
|
