Paper Title :Production And Characterization Of Aluminium-11% Silicon-3% Copper Alloy
Author :K. Srinivasa Vadayar, S. Devaki Rani
Article Citation :K. Srinivasa Vadayar ,S. Devaki Rani ,
(2014 ) " Production And Characterization Of Aluminium-11% Silicon-3% Copper Alloy " ,
International Journal of Mechanical and Production Engineering (IJMPE) ,
pp. 42-44,
Volume-2,Issue-3
Abstract : Abstract- Aluminium-11% Silicon-3% Copper alloy was produced by casting route. The variation of mechanical properties
of the alloy on as-received, homogenized, solution treatment, and after artificial ageing at 200°C has been studied.
Microstructural characterization studies and hardness values were investigated. The fractured samples were observed by
Scanning Electron Microscope. The present investigation revealed that the maximum tensile strength and hardness values
were in peak aged condition. Corrosive behaviour of as-received samples was studied in sea water environment and in severe
corrosive environment. It was found that appreciable resistance have been shown by as-received samples as revealed in the
icrostructures.
Type : Research paper
Published : Volume-2,Issue-3
DOIONLINE NO - IJMPE-IRAJ-DOIONLINE-567
View Here
Copyright: © Institute of Research and Journals
| |
 |
| |
 |
PDF |
| |
Viewed - 55 |
| |
Published on 2014-03-26 |
|
