International Journal of Mechanical and Production Engineering (IJMPE)
.
Follow Us On :
current issues
Volume-12,Issue-1  ( Jan, 2024 )
Past issues
  1. Volume-11,Issue-12  ( Dec, 2023 )
  2. Volume-11,Issue-11  ( Nov, 2023 )
  3. Volume-11,Issue-10  ( Oct, 2023 )
  4. Volume-11,Issue-9  ( Sep, 2023 )
  5. Volume-11,Issue-8  ( Aug, 2023 )
  6. Volume-11,Issue-7  ( Jul, 2023 )
  7. Volume-11,Issue-6  ( Jun, 2023 )
  8. Volume-11,Issue-5  ( May, 2023 )
  9. Volume-11,Issue-4  ( Apr, 2023 )
  10. Volume-11,Issue-3  ( Mar, 2023 )

Statistics report
Apr. 2024
Submitted Papers : 80
Accepted Papers : 10
Rejected Papers : 70
Acc. Perc : 12%
Issue Published : 130
Paper Published : 2388
No. of Authors : 6802
  Journal Paper


Paper Title :
Investigations Into the Causes of High Vibrations in Case of a Circulating Water Pump Motor

Author :Lokesh N Rai, Awtar Narain Mathur

Article Citation :Lokesh N Rai ,Awtar Narain Mathur , (2017 ) " Investigations Into the Causes of High Vibrations in Case of a Circulating Water Pump Motor " , International Journal of Mechanical and Production Engineering (IJMPE) , pp. 48-51, Volume-5,Issue-2

Abstract : A two pole circulating water pump motor vibrations under coupled run were extremely high. Normally, the problems with such motors are that of dynamic unbalance, resonance, misalignment or poor foundation. But the motor under study was found to be free from all these problems. The motor has been performing well for over 800 hours but was lying idle for few weeks prior to taking this run. The solo run of motor exhibited comparatively low vibrations but multiple frequencies of rotational speed were observed. Thus thorough investigations were made to establish the cause of this typical behavior. Phase measurement technique was applied and rotor bent was ruled out. The problem was ultimately traced to poor bearing condition, which was then improved. However after coupling with the cooling pump again, vibrations were increased. This was controlled by in situ balancing and the problem was resolved. This paper presents the description of the entire diagnosis process and test results obtained at each stage of analysis with major findings. The analysis can be used for diagnosis of the causes responsible for the vibration problems of any large motor. Key Words- Spectrum, phase measurement technique, in-situ balancing, frequency components, coupling, amplitude.

Type : Research paper

Published : Volume-5,Issue-2


DOIONLINE NO - IJMPE-IRAJ-DOIONLINE-7009   View Here

Copyright: © Institute of Research and Journals

| PDF |
Viewed - 73
| Published on 2017-04-19
   
   
IRAJ Other Journals
IJMPE updates
Volume-12,Issue-1 (Jan, 2024 )
The Conference World

JOURNAL SUPPORTED BY