Paper Title :Optimization of Process Parameter for Digital Light Processing (DLP) 3d Printing
Author :Afizah Ibrahim, N Sa’ude, M Ibrahim
Article Citation :Afizah Ibrahim ,N Sa’ude ,M Ibrahim ,
(2017 ) " Optimization of Process Parameter for Digital Light Processing (DLP) 3d Printing " ,
International Journal of Mechanical and Production Engineering (IJMPE) ,
pp. 116-119,
Volume-5,Issue-6
Abstract : Digital Light Processing (DLP) 3D printer which have similar process as SLA currently become a promising
printing method among toolmakers for its ability to create objects faster than SLA. Process parameter is one of significant
element used to enhance the quality of printed part. This paper attempt to investigate the influence of process parameter
which are layer thickness and exposure time on physical and mechanical properties of DLP structure. The physical properties
include surface finish and dimension accuracy whereas the mechanical properties covers ultimate tensile strength and the
flexural properties of printed parts. The study is conducted on test sample of B9R-1-Red built using B9 Creators machine.
All the samples are tested under specific ASTM test conditions. The finding results shows that layer thickness of 50 μm with
exposure time of 9 sec have tensile and flexural strength of 8.98 N/mm2 and 18.39 N/mm2 respectively. As for dimensional
accuracy, the percentage difference across dimension of B9R-1-Red is found to be 3.8%. It was found that for B9R-1-Red,
the layer thickness of 50 μm with exposure time of 9 sec would provide the best mechanical properties along with minimum
dimensional error.
Keywords: Digital Light Processing, Process Parameter, Layer Thickness, Exposure Time, Mechanical Properties.
Type : Research paper
Published : Volume-5,Issue-6
DOIONLINE NO - IJMPE-IRAJ-DOIONLINE-8501
View Here
Copyright: © Institute of Research and Journals
|
|
| |
|
PDF |
| |
Viewed - 54 |
| |
Published on 2017-08-30 |
|