Paper Title :Performance Analysis and Experimental Investigation for Reducing Cutting Tool Wear Rate by Cryoenic Technique
Author :Vidyasagar Matta, Panyam Vishnu Vardhan Reddy, Kondraganti Venkatesh
Article Citation :Vidyasagar Matta ,Panyam Vishnu Vardhan Reddy ,Kondraganti Venkatesh ,
(2017 ) " Performance Analysis and Experimental Investigation for Reducing Cutting Tool Wear Rate by Cryoenic Technique " ,
International Journal of Mechanical and Production Engineering (IJMPE) ,
pp. 12-15,
Volume-5,Issue-5
Abstract : The high speed steel is used as a cutting tool, as it has good quality and reliability at cheaper rate when compared
to other cutting tools. The cryogenic treatment process involves cooling down the samples to 93k (-180°c) soaking for 15-20
minutes and then slowly heating back to room temperature in 6 hrs. In this, solution having two sample pieces of round of
EN8 & EN19. A method called deep cryogenic process, subjects steel components placed in a specially constructed tank to
temperature around 77k (196°c) for half an hour using liquid nitrogen as the refrigerant. There is 34.17 seconds reduction in
machining time and there is no tool wear when machining EN8 and when machining EN 19 there is 22.04 seconds reduction
in machining time and 0.03g increase in tool wear resistance.
Type : Research paper
Published : Volume-5,Issue-5
DOIONLINE NO - IJMPE-IRAJ-DOIONLINE-10613
View Here
Copyright: © Institute of Research and Journals
| |
 |
| |
 |
PDF |
| |
Viewed - 63 |
| |
Published on 2018-03-12 |
|
