Paper Title :Tensile Strength of PLA Parts Produced by FDM 3D Printer
Author :Juraj Beniak, Peter Krizan, Milos Matus
Article Citation :Juraj Beniak ,Peter Krizan ,Milos Matus ,
(2018 ) " Tensile Strength of PLA Parts Produced by FDM 3D Printer " ,
International Journal of Mechanical and Production Engineering (IJMPE) ,
pp. 7-12,
Volume-6,Issue-1
Abstract : Many different types of materials are used for 3D printing. Each material have some advantages and disadvantages,
so there is really important proper selection of building material for model or final part production. Published paper present
actual results of research. Presented are results of tensile strength measurement on prepared specimens built from ecological
PLA plastic material. PLA plastic material is in this time the most used material for 3D printing with Fused Deposition
Modeling (FDM) or Fused Filament Fabrication (FFF) technology, because its really good and positive properties and easy
processing. This material is also ecological, because is produced from renewable sources, not from crude oil, which pollute our
environment. The whole testing and measurement was managed and controlled by a prepared experimental plan. There are
selected possible important factors, which are act in the experiment in two or three levels. Presented full factor experiment if
based on this input data. The results of measurement were evaluated by selected statistical method as ANOVA is.
Index Terms - 3D printing, Rapid Prototyping, Additive Manufacturing, Fused Deposition Modeling, PLA plastic material,
Tensile Strength.
Type : Research paper
Published : Volume-6,Issue-1
DOIONLINE NO - IJMPE-IRAJ-DOIONLINE-10673
View Here
Copyright: © Institute of Research and Journals
| |
 |
| |
 |
PDF |
| |
Viewed - 88 |
| |
Published on 2018-03-24 |
|
