Paper Title :Batch Pipe Forming Method Using Burring And Ironing of Diameter Steel Pipe by Fem Analysis
Author :Tatsuhiro Onizuka, Shuji Okubo, Hisamichi Ono, Shun Yasuhara, Shinichi Nishida
Article Citation :Tatsuhiro Onizuka ,Shuji Okubo ,Hisamichi Ono ,Shun Yasuhara ,Shinichi Nishida ,
(2022 ) " Batch Pipe Forming Method Using Burring And Ironing of Diameter Steel Pipe by Fem Analysis " ,
International Journal of Mechanical and Production Engineering (IJMPE) ,
pp. 1-4,
Volume-10,Issue-10
Abstract : Abstract - This paper describes Batch Pipe Forming Method Using Burring and Ironing of Large Diameter Steel Pipe. Branch pipes are one of the components of the piping system in a factory that serves as a flow path for gases and fluids. The bifurcated tube is formed by burring as a typical molding technique. The burring process is to form a branch pipe by raising the peripheral portion of the prepared hole formed in the mother pipe. There is a problem that the cutting of the edge is required in the post process. Therefore, a branch pipe batch forming method has been developed in which burring processing that does not require a cutting step in the subsequent step is combined with ironing processing using FEM analysis. The purpose of this study is to establish a batch forming method for branch pipes using the burring and ironing processes. Comparison of the analytical results with the experimental results suggests that a batch forming method for branch pipes can be performed using the burring and ironing processes.
Keywords - Burring, Steel Gas Pipe, Compression Test, Finite Element Method Analysis
Type : Research paper
Published : Volume-10,Issue-10
DOIONLINE NO - IJMPE-IRAJ-DOIONLINE-19035
View Here
Copyright: © Institute of Research and Journals
| |
 |
| |
 |
PDF |
| |
Viewed - 93 |
| |
Published on 2022-12-19 |
|
