Paper Title :Design And Manufacturing Of Forming Die For Reinforcement C & E Column Bottom Inner
Author :Atharva Bhave, P.K. Kale
Article Citation :Atharva Bhave ,P.K. Kale ,
(2016 ) " Design And Manufacturing Of Forming Die For Reinforcement C & E Column Bottom Inner " ,
International Journal of Advances in Mechanical and Civil Engineering (IJAMCE) ,
pp. 71-74,
Volume-3,Issue-1
Abstract : In this paper we have proposed design for die for producing part namely reinforcement C & E column bottom
inner. For producing part various sheet metal processes were which were blanking, forming, blanking etc. But our part only
required forming operation. So we designed forming die for that. Firstly tonnage calculations were made for die and
according to its press load press was used. After that as per design company manufactured die by using their standard
processes. Then final component obtained from die was inspected on inspection panel for dimension constraints and required
surface finish.
Keywords— Form Die, Inspection panel, Die Design.
Type : Research paper
Published : Volume-3,Issue-1
DOIONLINE NO - IJAMCE-IRAJ-DOIONLINE-4055
View Here
Copyright: © Institute of Research and Journals
|
|
| |
|
PDF |
| |
Viewed - 66 |
| |
Published on 2016-03-17 |
|